Fujitsu PRIMERGY TX100 S3 Core Edition Upgrade And Maintenance Manual

184 Upgrade and Maintenance Manual TX100 S3 Core Edition
Front panel and external connectors
13.2 Replacing the front USB module
13.2.1 Required tools
● Preliminary and concluding steps:
– Phillips PH2 / (+) No. 2 screw driver
● Replacing the front panel module:
– Phillips PH2 / (+) No. 2 screw driver
13.2.2 Preliminary steps
Before replacing the front USB module, perform the following steps:
Ê Shut down the server as described in section "Shutting down the server" on
page 40.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section "Disconnecting the power cord" on page 41.
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section "Removing the side cover" on
page 43.
Ê Remove all accessible drives as described in section "Removing accessible
drives" on page 163.
Ê Remove the front cover as described in section "Removing the front cover"
on page 49.
Ê Remove the HDD cage as described in section "Removing the HDD cage"
on page 60.
Field Replaceable Units (FRU)
Average task duration: 15 minutes

Fujitsu PRIMERGY TX100 S3 Core Edition Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX100 S3 Core Edition
Category	Server
Language	English