Step 4 Press the Menu/DSC control to save the setting and return to the previous
interface.
10.2.4 Bearing
This feature allows you to set the mode (magnetic or true).
Note
A GNSS receiver should be connected to the radio or the "INTERNAL GNSS"
should be set to "ON" to show the bearing.
Step 1 Press the Menu/DSC control until the "MAIN MENU" screen appears.
Step 2 Go to "GENERAL SETUP > UNITS > BEARING".
Step 3 Select "TRUE" or "MAGNETIC".
Step 4 Press the Menu/DSC control to save the setting and return to the previous
interface.
To Next Page
Loading...
