13. ATIS SETUP
The FM-4800 supports the Automatic Transmitter Identification System (ATIS) used
in Inland waterways in Europe. In the ATIS mode, the radio transmits a unique ATIS
code each time the PTT key is released at the end of a transmission. You should
check with your local marine regulatory authority in your country for assistance in
obtaining an ATIS code.
13.1 How to Enter the ATIS ID
You can register an ATIS ID, and also view the registered ID, as follows:
Caution
An ATIS ID can be entered only once. Therefore, be careful not to enter the
wrong ATIS ID. If you need to change the ID after it has been entered, contact
your dealer.
Step 1 Press the Menu/DSC control until the "MAIN MENU" screen appears.
Step 2 Go to "ATIS SETUP > SET ATIS ID ".
The following interface appears.
Step 3 Rotate and press the MENU/DSC control to enter your ATIS ID (nine
digits).
If you enter a wrong digit, press the BACK key until the wrong digit is
selected, and then enter a correct digit.
Step 4 After you enter the ATIS ID, press the Menu/DSC control to save it.
Step 5 Enter the ATIS ID again, and then press the Menu/DSC control to save it.
13.2 How to Enable/Disable the ATIS Feature
Step 1 Press the Menu/DSC control until the "MAIN MENU" screen appears.
Step 2 Select "ATIS SETUP".
The "ATIS SETUP" interface appears on the screen.
Step 3 Do one of the following:
To Next Page
Loading...
Need help?
General
