Furuno RD-50 User Manual

ii
SAFETY INSTRUCTIONS
WARNING
Do not disassemble or modify
the equipment.
Fire, electrical shock or serious
injury can occur.
WARNING
Indicates a condition that can cause death or serious
injury if not avoided.
CAUTION
Indicates a condition that can cause minor or moderate
injury if not avoided.
Safety Instructions for the Operator Safety Instructions for the Installer
Be sure that the power supply is
compatible with the voltage rating
of the equipment.
Connection of an incorrect power
supply can cause fire or equipment
damage. The voltage rating of the
equipment appears on the label
above the power connector.
Turn off the power immediately if
water leaks into the equipment or
smoke or fire is coming from the
equipment.
Failure to turn off the equipment can
cause fire or electrical shock.
Contact a FURUNO agent for service.
Keep heater away from the
equipment.
Heat can change the equipment
shape and meltthe power cord, which
can cause fire or electrical shock.
WARNING
CAUTION
Turn off the power at the
switchboard before you install
the equipment.
Fire or electrical shock can occur if
the power is left on.
Ground the equipment to
prevent mutual interference.
Observe the following compass safe
distances to prevent interference to
a magnetic compass:
RD-50
Standard
compass
Steering
compass
0.45 m 0.30 m
RD-501 1.30 m 0.85 m
RD-502 1.00 m 0.65 m
Model
RD-50
+
DS-605
0.95 m 0.60 m
Use the correct fuse.
A wrong fuse can damage the
equipment and cause fire.
The TFT LCD is constructed using the
latest LCD techniques, and displays
99.99% of its pixels. The remaining 0.01%
of the pixels may drop out or blink, however
this is not an indication of malfunction.
About the TFT LCD

Furuno RD-50 Specifications

General

Brand	Furuno
Model	RD-50
Category	Monitor
Language	English