2. MENU
2-25
2.14 Time Setup
2.14.1 How to select the time source
You can select the time source from [Internal], [External] or [NAV EQUIP].
1. Press the MENU/ESC key to open the menu.
2. Press S or T key to select [Ship’s Time] and press the ENT key.
Ship’s Time options
3. Press S or T key to select [Source] and press the ENT key.
Source options
4. Press S or T key to select [Internal], [External] or [NAV EQUIP] then press the
ENT key. If you selected [Internal], go to step 5. For the others, go to step 6.
[Internal]: Display the local time using own RD-50 data which is set at step 5.
[External]: Only for the RD-50 (sub). When you connect multiple RD-50s in a dai-
sy chain, display the time using the RD-50 (main) data. In this case the RD-50
(main) should be set to [Internal] or [NAV EQUIP]. When you set the [Remote Dim-
mer] to [Main] on the [Service menu], this option is not available.
[NAV EQUIP]: Display the time data from the navigational equipment.
5. For [Internal], press S or T key to set the time differences from UTC (Universal
Time Coordinated) at 15 minutes intervals and press the ENT key.
Internal setting window
To Next Page
Loading...
Need help?
General
