Garmin G1000:Socata User Manual

190-00709-00 Rev. A Garmin G1000 Pilot’s Guide for the Socata TBM 850 4-34
AUDIO PANEL AND CNS
VFR CODE
The VFR code can be entered either manually or by selecting the XPDR Softkey, then the VFR Softkey.
When the
VFR Softkey is selected, the pre-programmed VFR code is automatically displayed in the code field
of the Transponder Data Box. Selecting the
VFR Softkey again restores the previous identification code.
The pre-programmed VFR Code is set at the factory to 1200. If a VFR code change is required, contact a
Garmin-authorized service center for configuration.
Figure 4-43 VFR Code
VFR Code
IDENT FUNCTION
NOTE: In Standby Mode, the IDENT Softkey is inoperative.
Selecting the IDENT Softkey sends an ID indication to Air Traffic Control (ATC). The ID return distinguishes
one transponder from all the others on the air traffic controller’s radar screen. The
IDENT Softkey appears on
all levels of transponder softkeys. When the
IDENT Softkey is selected, a green IDNT indication is displayed in
the mode field of the Transponder Data Box for a duration of 18 seconds.
After the
IDENT Softkey is selected while in Mode or Code Selection, the system reverts to the top-level
softkeys.
Select the
IDENT Softkey
to Initiate the
ID Function
IDNT
Indication
Figure 4-44 IDENT Softkey and Indication

Garmin G1000:Socata Specifications

General

Brand	Garmin
Model	G1000:Socata
Category	Avionics Display
Language	English