Garmin G1000 Pilot’s Guide for the Socata TBM 850
190-00709-00 Rev. A1-34
SYSTEM OVERVIEW
MFD SYSTEM PAGES
In the Auxiliary (AUX) Page Group, there are two system pages: System Setup (page 5 of 6) and System Status
(page 6 of 6). The System Setup Page allows management of various system parameters, while the System
Status Page displays the status of all G1000 System LRUs.
SYSTEM SETUP PAGE
The System Setup Page allows management of the following system parameters:
• Pilot profiles
• Time display format (local or UTC )
• Displayed measurement units
• Baro transition alert (see Flight Instruments
Section)
• Airspace alerts
• Arrival alerts (see Flight Management Section)
• Audio alert voice
• Flight director format (see AFCS Section)
• MFD Data Bar fields
• GPS Course Deviation Indicator (CDI) range
• COM transceiver channel spacing
• Displayed nearest airports
Figure 1-32 System Setup Page
MFD Data Bar
Fields Box
GPS CDI Box
COM
Configuration
Box
Nearest
Airports Box
Date/Time Box
Display Units
Box
Audio Alert Voice
Selection
Pilot Profile
Setup
Airspace
Alerts Box
Select Waypoint
Arrival Alert
Flight Director
Command Bar Format
Select Baro
Transition Alert
CDI and Altimeter
Baro Sync
DATE/TIME
The Date/Time Box on the System Setup Page displays the current date and time and allows the pilot
to set the time format (local 12-hr, local 24-hr, or UTC) and offset. The time offset is used to define
current local time. UTC (also called “GMT” or “Zulu”) date and time are calculated directly from the GPS
satellites signals and cannot be changed. When using a local time format, designate the offset by adding or
subtracting the desired number of hours.
To Next Page
Loading...
Need help?
General
