10
CONNECTING THE TELEPHONE LINE
On the base, plug the one end of the telephone line cord into the jack on
the back of the base and the other end into a modular phone jack.
NOTE: One base unit can support up to two handsets.
CONNECTING THE AC (ELECTRICAL) POWER
1. Plug the power supply cord into the power jack on the back of the
base and the other end into an electrical outlet.
2. Plug the handset charge cradle into an electrical outlet.
3. Place one handset in each cradle. The charge indicators turn on to
indicate the batteries are charging.
CAUTION: Use only the ATLINKS USA, Inc. power supply 5-2579 that
came with this unit. Using other power supplies may damage the unit.
Allow the system to charge for 12 hours prior to first use. If you don’t
properly charge the phone, battery performance is compromised.
INSTALLING THE PHONE
Choose the best location to install your base and handset charge cradle.
Your base and handset charge cradle should be placed on a level surface
such as a desk or table top, or you may mount the base on a wall.
To Next Page
Loading...
Need help?
General
