Chapter 4: General Information
5495975-1EN Rev.9 4-9
© 2013-2017 General Electric Company. All rights reserved.
Emergency Stop
Emergency stop immediately powers down the system—including table, OTS, wallstand, and x-ray tube—
and stops image exposure. The digital table and RCIM are equipped with Emergency Stop buttons
(Figure 4-8).
To engage: Press the button.
To release: Turn (RCIM) or pull (table) the e-stop button to release.
Figure 4-8 Emergency Stop buttons
Use this procedure to perform an emergency stop and to reset the Emergency Stop button.
1. In an emergency situation, press the Emergency Stop button in with force.
2. Resolve the emergency situation.
CAUTION For Digital table, when the Emergency Stop button has been activated, the table
will move longitudinally only. The table is not locked into position. Exercise
extreme caution with your patient when this happens.
3. When normal conditions are confirmed, turn (RCIM) or pull (table) the e-stop button to reset.
ï‚· The system will power up automatically.
Note: If turn the e-stop button on RCIM to reset, turn the button clockwise (indicated by the arrows on
the button) until it stops, then release.
RCIM
Digital Table Standard Table
To Next Page
Loading...
Need help?
General
