1. Phased Array Operation—Keypad, Menus, and Displays
PHASOR XS Operating Manual Page 13
1.6 Startup Mode
Each time the instrument is powered on, the WELCOME
screen is displayed. This screen allows the user to select
PHASED ARRAY or CONVENTINAL mode. Alternatively,
the instrument can be configured to automatically start
in the previously active mode. To set the START UP
mode:
Step 1: Activate the STARTUP Submenu (Located in
the CONFIG MENU) by pressing
below it. Selections
will appear down the left side of the display.
Step 2: Press
next to STARTUP MODE to select
one of the following:
WELCOME – Display allows the user to select
PHASED ARRAY or CONVENTIONAL operation
each time the instrument is powered on.
LAST – Instrument automatically powers on in the
mode that was last active.
At any time, the operating mode can be changed by press-
ing
to access the WELCOME screen.
1.7 Software Updates
If software updating is required, the instrument’s up-
dated software can be downloaded from our website:
www.GEInspectionTechnologies.com
To Next Page
Loading...
Need help?
General
