GE RAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
3-82 Section 3-12 - Network Configuration
3-12-4 How to Setup E-mail to MMS Service
If the Voluson™ P8/Voluson™P6 is connected to the Internet (via LAN, Wi-Fi) and E-mail service is
configured properly, it is possible to send images as an MMS.
NOTE: MMS are sent by e-mail to a 3rd party provider (e.g. SMSglobal). This service needs to be ordered by
a 3rd party provider.
Registration of MMS Service
To use the MMS feature you need to contract with a 3rd party provider which offers E-mail to MMS
service (e.g. SMSglobal). Please contact the service provider!
How this feature works
Voluson™ P8/Voluson™P6 Series sends an E-mail with an attached image to the E-mail to MMS
service. The MMS phone number is encapsulated in the recipient E-mail address
MMS Options
1.) Press the Utilities H key on the control console.
2.) In the “Utilities” menu select the System Setup button to invoke the setup desktop on the screen.
3.) On the left side of the screen select Connectivity and then click the Device Setup tab.
4.) Click the Email Configuration button; see Figure 3-64 on page 3-71 .
5.) In the Email Configuration screen check box "Use Email to MMS Service" and then click on
Settings.
The Email to MMS Service Settings window appear.
NOTE: The configuration above works with SMSglobal.
6.) Enter the Domain Name from 3rd party E-mail to MMS service.
Note:
An E-mail to phone number@Domain Name for MMS Email is sent!
7.) Store your configuration with click on OK.
8.) Individually enter Patient's Email address and Phone number in the PID screen and adjust Email
and/or MMS options as described in Figure 3-12-5 on page 3-83 .
Figure 3-72 check box
Figure 3-73 Email to MMS Service Settings
To Next Page
Loading...
Need help?
General
