Hardi SMARTCOM ISOBUS UT SW A.2.2 Series User Manual

3 - Description
62
Menu 3.6 Track calibration
There is no standard setting for the Track setup. The Track needs to
be adjusted to the actual conditions, for different kinds of tractors,
setup of the sprayer and spraying practices.
Each adjustment and the effect it will have on the sprayer, is
described below.
Menu 3.6.1 Track width
Here the track width can be entered.
• The track width is measured from right side tyre centre to left
side tyre centre of the sprayer wheels.
It is important that the right track width is entered. The controller
will calculate the speed at the centre of sprayer, and not at the
wheel sensor as speed varies in right and left turns.
μ
ATTENTION! If the track width is incorrect, it will influence on
track precision and the roll-over risk factor (menu 3.6.6).
Factory setting: 180 cm
Menu 3.6.2 Tractor drawbar
Here the length of the tractor drawbar is entered. This has to be
adjusted every time a new tractor is attached to the sprayer.
• The measurement is from the centre of the tractor rear axle
to the centre of the drawbar pin.
μ
ATTENTION! When attached, check the rigidity of the tractor
drawbar mounts. There may be no sideways movement.
Factory setting: 80 cm
Inaccurate Drawbar Measurement
An inaccurate drawbar measurement will cause the sprayer to
steer unintended:
• Too short measurement = Track react faster, i.e. steer too early.
• Too long measurement = Track react slower, i.e. steer too late.
Track calibration
Speed calibration
Flow calibration
Boom setup
Regulation user setup
Tank gauge calibration
Track calibration
Track width, tractor drawbar
length, damping, alignment,
sensitivity set up
Menu
Track width
Track width of the sprayer
wheels measured center
to center
Tractor drawbar
Measure the length
from tractor rear axle
to drawbar connection

Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Specifications

General

Brand	Hardi
Model	SMARTCOM ISOBUS UT SW A.2.2 Series
Category	Farm Equipment
Language	English