Hardi SMARTCOM ISOBUS UT SW A.2.2 Series User Manual

4 - System Setup
72
Boom Settings
Prior to the use of the SmartCom sprayer it needs to be set up with boom data.
Menu 3.3.1 Width
Check that correct boom width is set.
÷
NOTE! This menu is read only. Boom width is factory set for
the specific sprayer configuration.
Menu 3.3.2 Number of sections
Check that correct number of boom sections is set.
÷
NOTE! This menu is read only. Number of sections is factory
set for the specific sprayer configuration.
Menu 3.3.3 Nozzles/sections
1. Set correct number of nozzles per section.
2. Press to continue to next boom section.
3. Press after the last section.
÷
NOTE! This menu may already be set by the HARDI Service
Centre.
Width
meter
The total spray boom width.
Include end nozzles if fitted
Number of sections
sections
The number of spray boom
sections. Keyin, then press
Enter
Nozzles / sections
nozzles
Use arrow keys or numeric
keys, then press Enter to set
up section 1

Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Specifications

General

Brand	Hardi
Model	SMARTCOM ISOBUS UT SW A.2.2 Series
Category	Farm Equipment
Language	English