Hardi SMARTCOM ISOBUS UT SW A.2.2 Series User Manual

5 - Operation
86
Register Readout and Selection
The register is identified by a number in the upper right corner of the work display. The data is memorized when the system
is switched off.
In this menu it is possible to see the register used for logging individual spray data.
To Read the Data in the Active Register
1. Go to menu [1.3.1 Show register spray data 1].
2. Press to enter register and read main data.
3. Press again to see spray data.
4. Press to exit the menu.
To Read the Totals of Registers
1. Go to menu [1.3.3 Total register].
2. Press to enter the register and read main data.
3. Press again to see spray data.
4. Press to exit the menu.
To Reset Register
Press to reset register.
μ
ATTENTION! Reset of a register can not be stopped, as pressing will immediately reset the register!
÷
NOTE! The active register number is always visible in the right upper corner of the display.
Select register
Menu
Show register spray data 1
Select register
Total register
Use register 1 to 99 for job.
Scroll to register, then press
Enter to show data
Select register
Menu
Show register spray data 1
Select register
Total register
Shows register number 0 which
is a total of all registers

Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Specifications

General

Brand	Hardi
Model	SMARTCOM ISOBUS UT SW A.2.2 Series
Category	Farm Equipment
Language	English