Hardi SMARTCOM ISOBUS UT SW A.2.2 Series User Manual

71
4 - System Setup
Initial Settings
System Start-up
When turned ON:
• The system initiates itself.
• If the system is put into operation for the very first time it will prompt for date and time.
Display Readout
It is possible to freely choose which functions to be shown in the 5
boxes (B), (C), (D) and (E) of the display.
Box (A) will always show the actual volume rate.
The large box shows the same as box (A), as default. This can be
changed to another readout by pressing one of the preset keys.
However, this readout will change back to the actual volume rate
when the controller is rebooted.
Readout Selection
1. Go to menu [2.1 Display readout].
2. Use or to choose which of following boxes you
want the data shown and press to confirm.
2.1.1 Show upper middle (B)
2.1.2 Show upper right (C)
2.1.3 Show lower middle (D)
2.1.4 Show lower right (E)
3. Choose a submenu e.g. menu [2.1.1.04 Work rate]. Press to confirm.
4. Press to leave menu.
μ
ATTENTION! For a full list of possible readouts, please refer to menu 2.1.1, menu 2.1.2, menu 2.1.3, menu 2.1.4 and
menu 2.1.5 in “Full Menu Structure” on page 37.
ESC Key Setup
In menu 2.1.5 it can be selected how the ESC key is operated.
• Menu 2.1.5.1:
Select this menu if there is no ESC button on the ISOBUS
Terminal.
• Menu 2.1.5.2:
Select this menu if the ISOBUS Terminal has a physical ESC
button.
μ
ATTENTION! Do only select menu 2.1.5.2 if the ISOBUS
Terminal has a physical ESC button!
Boom pressure Slant angle
Prog. rate
Prog. rate
Prog. rate
Boom pressure
bar
bar
degree
liter / ha
liter / ha
liter / ha

Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Specifications

General

Brand	Hardi
Model	SMARTCOM ISOBUS UT SW A.2.2 Series
Category	Farm Equipment
Language	English