Hardi SMARTCOM ISOBUS UT SW A.2.2 Series User Manual

9
2 - Safety Notes
Operator Safety
Explanation of Symbols
Safety symbols are used in the following chapters throughout this Instruction Book to designate, where the reader has to
pay extra attention.
The signal word (DANGER, WARNING, ATTENTION or NOTE) describes the severity of the risk.
The symbols have the following meaning:
€
This symbol means DANGER. Be very alert as your safety is involved! The DANGER symbol indicates a high risk for an
immediate death or serious physical injury, if the instruction is not followed.
±
This symbol means WARNING. Be alert as your safety can be involved! The WARNING symbol indicates a medium risk
for immediate death or serious injury, if the instruction is not followed.
μ
This symbol means ATTENTION. This indicates an obligation to special behaviour or an activity required for proper
sprayer handling. This instruction will help you to avoid faults on the sprayer or disturbance to the environment.
÷
This symbol means NOTE. This indicates handling tips and particularly useful information. This instruction will help
you to use all the functions of your sprayer in the best way possible for a better, easier and more safe operation.
Precautions
Note the following recommended precautions and safe operating practices before using the sprayer.
General Info
€
Read and understand this instruction book before using the equipment. It is equally important that other operators
of this equipment read and understand this book.
If any portion of this instruction book remains unclear after reading it, contact your HARDI dealer for further
explanation before using the equipment.
€
Keep children away from the equipment.
€
Local law may demand that the operator is certified to use spray equipment. Adhere to the law.
€
Tractor drivers seat is the intended working place during operation.
Service
€
Never service or repair the equipment while it is operating. Always replace all safety devices or shields immediately
after servicing.
€
Turn electrical power off before connecting and disconnecting the display and transducers, servicing or using a
battery charger.
€
If an arc welder is used on the equipment or anything connected to the equipment, disconnect power leads before
welding. Remove all inflammable or explosive material from the area.
€
Do not use a high pressure cleaner to clean the electronic components.

Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Specifications

General

Brand	Hardi
Model	SMARTCOM ISOBUS UT SW A.2.2 Series
Category	Farm Equipment
Language	English