Hardi SMARTCOM ISOBUS UT SW A.2.2 Series User Manual

3 - Description
69
Menu 4.6.3 Reset nozzle position in SMCU
If a SMCU has assigned a ID number it has to be reset before it can
be reused on another position on a boom.
The LED is flashing if the SMCU has a ID number assigned. If the
LED lit up constant the SMCU is not programmed.
PrimeFlow setup
Menu
Test Nozzle positions
Assign nozzle position to SMCU
Reset nozzle position in SMCU

Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Specifications

General

Brand	Hardi
Model	SMARTCOM ISOBUS UT SW A.2.2 Series
Category	Farm Equipment
Language	English