HIKVISION DS-2TD2667-35/PY User Manual

Chapter 3 Network Settings
3.1 TCP/IP
TCP/IP settings must be properly congured before you operate the device over network.
IPv4 and IPv6 are both supported. Both versions can be congured simultaneously without
conicting to each other.
Go to Conguration > Basic Conguration > Network > TCP/IP for parameter settings.
NIC Type
Select a NIC (Network Interface Card) type according to your network condition.
IPv4
Two IPv4 modes are available.
DHCP
The device automatically gets the IPv4 parameters from the network if you check
DHCP. The device IP address is changed after enabling the function. You can use
SADP to get the device IP address.
Note
The network that the device is connected to should support DHCP (Dynamic Host
Conguration Protocol).
Manual
You can set the device IPv4 parameters manually. Input IPv4 Address, IPv4 Subnet
Mask, and IPv4 Default Gateway, and click Test to see if the IP address is available.
IPv6
Three IPv6 modes are available.
Route Advertisement
The IPv6 address is generated by combining the route advertisement and the device
Mac address.
Note
Route advertisement mode requires the support from the router that the device is
connected to.
DHCP
The IPv6 address is assigned by the server, router or gateway.
Manual
Thermal & Optical Bi-spectrum Network Camera User Manual
6

HIKVISION DS-2TD2667-35/PY Specifications

General

Brand	HIKVISION
Model	DS-2TD2667-35/PY
Category	Security Camera
Language	English