3.7 Access to Device via PPPoE Dial Up Connection
This device supports the PPPoE auto dial-up function. The device gets a public IP address
by ADSL dial-up after the device is connected to a modem. You need to congure the
PPPoE parameters of the device.
Steps
1.
Go to
Conguration > Network > Basic Settings > PPPoE .
2.
Check Enable PPPoE.
3.
Set the PPPoE parameters.
Dynamic IP
After successful dial-up, the dynamic IP address of the WAN is displayed.
User Name
User name for dial-up network access.
Password
Password for dial-up network access.
Conrm
Input your dial-up password again.
4.
Click Save.
5.
Access the device.
By Browsers
Enter the WAN dynamic IP address in the browser address bar to
access the device.
By Client
Software
Add the WAN dynamic IP address to the client software. Refer to
the client manual for details.
Note
The obtained IP address is dynamically assigned via PPPoE, so the IP address always
changes after restarting the camera. To solve the inconvenience of the dynamic IP, you
need to get a domain name from the DDNS provider (e.g., DynDns.com). Refer to
Access
to Device via Domain Name
for detail information.
3.8 Set ISUP
When the device is registered on ISUP platform (formerly called Ehome), you can visit and
manage the device, transmit data, and forward alarm information over public network.
Steps
1.
Go to Conguration > Network > Advanced Settings > Platform Access .
2.
Select ISUP as the platform access mode.
3.
Select Enable.
Thermal & Optical Bi-spectrum Network Camera User Manual
11
To Next Page
Loading...
Need help?
General
