User Manual of DS-7200-ST Series DVR
76
Note: The Trigger Alarm Output option is not available for DS-7200HVI-ST/SE and DS-7200HFI-ST/SE
models as they provide no alarm in/out; and the Send Email option is invalid for DS-7204HVI-ST/SE model.
Video Tampering Detection
The video tampering can also be detected and set to trigger an action on your DVR.
Note: The video tampering detection area is in full-screen mode by default and cannot be configured.
To set up video tempering detection:
1. Click Menu > Settings > Camera to enter the Camera Settings menu, shown in Figure 18.
Figure 18. Camera Management Menu
2. Select the Advanced tab.
3. Select the camera to be configured with video tampering detection.
4. Check the Tamper Detection checkbox to enable this feature, as shown in Figure 19.
Figure 17. Camera Settings Menu
5. Click the Handle button to enter the Exception Handle menu, shown in Figure19.
6. Select the Schedule tab. Set the schedule you want video tampering detection to be enabled.
Schedule can be set for all week or any day of the week with up to 8 time periods per day.
Note: After having configured the schedule, the DVR must be restarted for the new settings to take effect.
To Next Page
Loading...
Need help?
General