User Manual of Network Video Recorder
106
14.8 RS-232 Configuration
Purpose:
The RS-232 port can be used in two ways:
• Parameters Configuration: Connect a PC to the NVR using the PC serial interface. Device parameters can be
configured by using software such as HyperTerminal. The serial port parameters must be the same as that of the
NVR when connecting with the PC serial port.
• Transparent Channel: Connect a serial device directly to the NVR. The serial device will be controlled remotely
by the PC via the network and the protocol of the serial device.
Steps:
1. Enter RS-232 Configuration interface:
Configuration> Remote Configuration> Serial Port Settings> 232 Serial Port
Figure 14. 5 RS-232 Configuration Interface
2. Configure RS-232 parameters, including baud rate, data bit, stop bit, parity, flow control and usage.
3. Click Save to save the settings.
To Next Page
Loading...
Need help?
General
