User Manual of Network Video Recorder
60
9.4 NTP Settings
Purpose:
A Network Time Protocol (NTP) Server can be configured on your NVR to ensure the accuracy of system
date/time.
Steps:
1. Enter the Network Settings interface.
Configuration> Remote Configuration> Device Parameters> Time Settings
2. Select the NTP tab to enter the NTP Settings interface, as shown in Figure 9. 7
Figure 9. 7 NTP Settings Interface
3. Check the Enable NTP checkbox to enable this feature.
4. Configure the following NTP settings:
• Interval: Time interval between the two synchronizing actions with NTP server. The unit is minute.
• NTP Server: IP address of NTP server.
• NTP Port: Port of NTP server.
5. Click Save to save the settings.
Note: The time synchronization interval can be set from1 to 10080 minutes, and the default value is 60 minutes. If
the NVR is connected to a public network, you can use a NTP server that has a time synchronization function, such
as the server at the National Time Center (IP Address: 210.72.145.44). If the NVR is setup in a private network,
NTP software can be used to establish a NTP server for time synchronization.
To Next Page
Loading...
Need help?
General
