User Manual of Network Video Recorder
26
In live view mode, you are allowed to use the PTZ control buttons to realize pan/tilt/zoom control of the camera.
Note: To realize PTZ control, the camera connected to the network must support the PTZ function or a pan/tilt
device is connected to the camera.
5.1 Configuring RS-485
Purpose:
Follow the procedure to set the parameters for PTZ. Configure the PTZ parameters should be done before you
control the PTZ camera.
Steps:
1. Enter the RS-485 Settings interface.
Configuration> Remote Configuration> Serial Port Settings> 485 Serial Port
Figure 5. 1 RS-485 Settings Interface
2. Choose the camera for PTZ setting in the drop-down list.
3. Edit the parameters of the PTZ camera.
Note: Only PTZ protocol and PTZ address can be configured, and the parameters should be exactly the same as
the PTZ camera parameters.
4. Click Save to save the settings.
To Next Page
Loading...
Need help?
General
