User Manual of Network Video Recorder
63
9.7 SNMP Settings
Purpose:
You can use SNMP protocol to get device status and parameters related information. By setting the Trap Address,
the device is allowed to send the alarm event and exception message to the surveillance center.
Before you start:
Please download the SNMP software and manage to receive the device information via SNMP port.
Steps:
1. Enter SNMP settings interface:
Configuration> Remote Configuration> Network Settings> SNMP
Figure 9. 10 SNMP Settings
2. Check the Enable SNMP v2c checkbox to enable this feature.
3. Configure the following SNMP settings:
Trap Address: IP Address of SNMP host.
Trap Port: Port of SNMP host.
4. Click to save the settings.
To Next Page
Loading...
Need help?
General
