OPERATOR'S STATION
1-54
CIGAR LIGHTER
Operation
IMPORTANT: In case cigar lighter (2) does not pop out au
-
tomatically 30 seconds after pushing cigar
lighter (2) in, pull out cigar lighter (2) manu-
ally. Then, consult the your nearest Hitachi
dealer.
1. Turn key switch (1) to the ACC or ON position.
2. Press and release cigar lighter (2) knob.
3. Cigar lighter (2) knob will return to the original position
when cigar lighter (2) becomes usable. Pull cigar lighter
(2) out to use.
4. After using cigar lighter (2), insert cigar lighter (2) into the
panel until the knob is seated in the original position.
Using Cigar Lighter (2) Port as External Power Source
Use cigar lighter (2) port to supply power to lighting equip-
ment for servicing the machine.
IMPORTANT: Only 24 V electric power is available from
cigar lighter (2) port on this machine. Never
connect accessories that use power other
than 24 V. Damage to the batteries and ac-
cessories may result.
Do not supply power to accessories for a
long time without running the engine. Fail-
ure to do so may discharge the batteries.
1. Pull cigar lighter (2) knob out.
2. Correctly insert the accessory socket into cigar lighter (2)
port.
3. Turn key switch (1) to the ACC or ON position. Power is
supplied to the connected accessory.
4. After using the accessory, disconnect the accessory
socket and insert cigar lighter (2) into the port.
M178-01-049
1
M1U1-01-021
2
Left Control
Lever
To Next Page
Loading...
Need help?
General
