Honeywell H4W2PER2 Series User Manual

Configuring Network Settings
37
Parameter Function
5. Close the command line.
Open your browser, type http://<IP address> in the address
bar, and then press Enter.
Configuring Port Settings
Go to Setup  Network Setup  Port.
Figure 6-2 Port
Port
Table 6-2 Port Configurations
Parameter Function
Max
Connection
Displays the maximum number of network connections for the same
camera. The value ranges from 1 to 20. The maximum number of
connections is 20.
TCP Port The default setting is 37777. You can modify this setting as necessary.
UDP Port The default setting is 37778. You can modify this setting as necessary.
HTTP Port The default setting is 80. You can modify this setting as necessary.
RTSP Port
The default setting is 554. The RTSP stream query format is:
Main stream:
rtsp://username:password@ip:port/cam/realmonitor?channel=1&subtype=0
Sub stream:
rtsp://username:password@ip:port/cam/realmonitor?channel=1&subtype=1
You are required to manually enter the following four items: Username,
Password, IP, and Port.
IP: The camera’s IP address.
Port: The default is 554. You can leave this field blank if you are using the
default value.
Follow the standard RTSP protocols. When the encode mode is MJPEG, the
maximum supported resolution is 2040×2040.

Honeywell H4W2PER2 Series Specifications

General

Brand	Honeywell
Model	H4W2PER2 Series
Category	Security Camera
Language	English