Configuring Video Analytics Settings
51
Figure 7-1 Motion Detection
T
able 7-1 Motion Detection Configurations
Parameter Function
Enable Check to enable Motion Detection.
Period
The camera Motion Detection function is activated during the specified
period.
See Configuring the Alarm Period on page 51.
You can configure up to six periods per day. Select a date. If you do not
select a date, the current setup will be applied to today only. You can
select All to apply the alarm period to the whole week.
Click Save to exit.
Anti-Dither
Enter the anti-dither time in seconds. Enter a value between 0 and 100
seconds. The system will only allow one motion detection event within
this period.
Area
Configure the motion detection region, its sensitivity, and area. The
default settings covers the entire area. Click Save to enable these
settings. See Configuring the Motion Detection Area on page 53.
Record If Record is enabled, a scene change event can activate recording.
Record Delay
The system will wait for the specified time before it begins recording.
Select from 10s to 300s.
Relay-out
Select the Relay-out check box, and when alarm is triggered, the system
To Next Page
Loading...
Need help?
General
