Performance Series IP Camera Software Configuration Guide
60
6. Click Draw Target at the right side of Pixel Counter, and then press and hold the left
mouse button to draw a rectangle, the Pixel Counter then displays its pixel.
7. Set rule parameters for IVS.
Table 7-5 Scene Change Configurations
Parameter Function
Period
The IVS function is activated during the specified period.
See Configuring the Alarm Period on page 51.
You can configure up to six periods per day. Select a date. If you do
not select a date, the current setup will be applied to today only.
You can select All to apply the alarm period to the whole week.Click
Save to exit.
Direction
Set the direction of rule detection.
•
When setting tripwire, select A->B, B->A, or A<->B.
•
When setting intrusion, select Enters, Exits, or Enter&Exit.
Target Filter Select the check box to enable the smart Tripwire/ Intrusion function.
Effective object
Includes Human and Motor vehicle. When you select Human, the
camera will detect human and non-motorized vehicle.
Record If Record is enabled, a scene change event can activate recording.
Record Delay
The system will wait for the specified time before it begins recording.
Select from 10s to 300s.
Relay-out
Select the Relay-out check box, and when alarm is triggered, the
system interacts with the linked alarm devices.
Alarm Delay
The Alarm linkage keeps running for the configured time after alarm is
ended.
Send Email When enabled, the system sends an email alert when an alarm occurs.
Snapshot
When enabled, the system attaches a snapshot to an email alert when
an alarm occurs.
8. Click Save.
Configuring Face Detection
Note
This function is only supported by
H4W4PER3V/H4W4PER2V/HBW4PER1V/HBW4PER2V/HEW4PER3V/HEW4PE
R2V/H2W4PER3V/H4W8PER2V/HBW8PER2V/HEW8PER2V/H4W8PER1V/HBW
8PER1V.
Go
to Setup Video Analytics Face Detection.
To Next Page
Loading...
Need help?
General
