Honeywell H4W2PER2 Series User Manual

Performance Series IP Camera Software Configuration Guide
56
Table 7-3 Scene Change Configurations
Parameter Function
Enable Check to enable scene change.
Period
The camera scene change function is activated during the specified
period.
See Configuring the Alarm Period on page 51.
You can configure up to six periods per day. Select a date. If you do
not select a date, the current setup will be applied to today only.
You can select All to apply the alarm period to the whole week.
Click Save to exit.
Record If Record is enabled, a scene change event can activate recording.
Record Delay
The system will wait for the specified time before it begins recording.
Select from 10s to 300s.
Relay-out
Select the Relay-out check box, and when alarm is triggered, the
system interacts with the linked alarm devices.
Alarm Delay
The Alarm linkage keeps running for the configured time after alarm is
ended.
Send Email When enabled, the system sends an email alert when an alarm occurs.
Snapshot
When enabled, the system attaches a snapshot to an email alert when
an alarm occurs.
Configuring Audio Detection Settings
Note
This function is supported by
H4W2PER2V/HBW2PER2V/HEW2PER3V/H4W4PER3V/H4W4PER2V/HEW4PE
R2V/HEW4PER3V/HBW4PER2V/H4W8PER1V/H4W8PER2V/HEW8PER2V/HB
W8PER2V/HBW8PER1V.
1. Go to Setup  Video Analytics  Audio Detection.
2. Configure the parameters.

Honeywell H4W2PER2 Series Specifications

General

Brand	Honeywell
Model	H4W2PER2 Series
Category	Security Camera
Language	English