ID3000/ID2000 Fire Panel Configuration Tool Manual
Introduction
1 - 21 997-291, Version 3.05
November 2010
Custom Logo Bitmap
The bitmap must be monochrome (white areas
appear green on the panel display), maximum
size 240 pixels wide and 52 pixels high. If
smaller it is placed in the top left of the display.
If larger, an error message is displayed.
The bitmap is not saved in the configuration
(it is cleared from the Tool when the
configuration is closed) so it must be selected
before the configuration is sent to the panel
or repeater.
1 Either:
a. Select the required bitmap, or
b. Select a blank (default: all-black) display.
2 If the chosen bitmap is smaller than 240 x
52 pixels, options are provided to:
a. Stretch it to full size (if this box is checked
the remaining options are then greyed).
b. Centre the bitmap.
c. Select the colour of unfilled areas (or of the
blank). Check box for white (appears green
on the panel display), or uncheck for black.
If the bitmap is full size these options are
greyed.
3 Click OK to close the Select Bitmap Logo
window and retain the bitmap, then Send
the panel configuration (Section 1.5.8) or
repeater configuration (Section 1.5.5).
(Closing the window by its ‘ ’ button will
clear the bitmap from the data buffer).
1a
2a 2b 2c 3
Click ‘Reset’ to
clear all selections
1b
To Next Page
Loading...
Need help?
General
