997-291, Version 3.05
November 2010
ID3000/ID2000 Fire Panel Configuration Tool Manual
Panel Settings
2 - 25
2.13 VdS Network Options
Only available when VdS mode is selected on
the Specification Tab. These settings configure
how the testing of the ÜE circuits, using the
ÜE PRUFEN button on the FBF panel, are
performed. Testing can be carried out from any
FBF panel on the network or from the FBF
panel connected directly to the panel where
the test is to be performed. Edit as follows:
1 This is available only if a Remote Fire
Output has been configured for sounder
circuit 1. Select the appropriate option for
local ÜE circuit 1. If the option for a
dedicated panel is selected use the spin
buttons to select the panel node (node
range up to 63) that has the FBF panel
attached.
2 This is available only if a Remote Fire
Output has been configured for sounder
circuit 2. Select appropriate option as for
step 1, if applicable.
3 This is only configurable with networks with
one or more superviser panels. Select
whether actions from the FBF panel affects
all sectors supervised by the fire control
panel, or whether the scope of action is
limited to the panel’s local sector.
1
2
3
To Next Page
Loading...
Need help?
General
