Honeywell Notifier ID3000 User Manual

ID3000/ID2000 Fire Panel Configuration Tool Manual
Introduction
1 - 14 997-291, Version 3.05
November 2010
1.5.8 Communications Menu
This menu has the following options:
a. Set up COM Port. Displays the Connection
Information Setup window.
b. Receive from Panel. Prompts for the
required database (via an ‘Open’ window),
then prompts for a Level 3 passcode and
displays the ‘Receive’ window (see next
page). Used to copy the panel’s
configuration into the Tool. Connect the PC
(see Section 1.4) and then select Receive
from Panel.
c. Send to Panel. Prompts for a Level 3
passcode, then displays the ‘Send’ window
(next page +1). Used to load the
configuration to the panel. Connect the PC
(see Section 1.4) and then select Send to
Panel.
‘Send to Panel’ is
only available
when a panel
configuration is
displayed in the
Tool window
If the Tool ‘hangs’ during a
‘Receive’ or ‘Send’, check
that the correct
Communication Port has been
selected.
Connection Information Setup Window
Allows the communications port for your PC
tool to be set. The application automatically
finds and displays the available
communication port(s).
1 Use the drop-down menu to select the port
you are going to connect for upload/
download.
2 Select OK.
1
2

Honeywell Notifier ID3000 Specifications

General

Brand	Honeywell
Model	Notifier ID3000
Category	Control Panel
Language	English