HP 1920 Gigabit Ethernet Switch Series User Manual

461
Item Descri
p
tion
MAC
Address
Filter
Source MAC
Address
Select the Source MAC Address box and enter a source MAC address and
a mask.
Source Mask
Destination MAC
Address
Select the Destination MAC Address box and enter a destination MAC
address and a mask.
Destination Mask
COS(802.1p priority) Specify the 802.1p priority for the rule.
Type Filter
LSAP Type
Select the LSAP Type box and specify the DSAP and SSAP fields in the LLC
encapsulation by configuring the following items:
• LSAP Type—Frame encapsulation format.
• LSAP Mask—LSAP mask.
LSAP Mask
Protocol Type
Select the Protocol Type box and specify the link layer protocol type by
configuring the following items:
• Protocol Type—Frame type. It corresponds to the type-code field of
Ethernet_II and Ethernet_SNAP frames.
• Protocol Mask—Protocol mask.
Protocol Mask
Time Range Select the time range during which the rule takes effect.
Adding an IPv6 ACL
1. Select QoS > ACL IPv6 from the navigation tree.
2. Click the Add tab.
The IPv6 ACL configuration page appears.
Figure 450 Adding an IPv6 ACL
3. Add an IPv6 ACL.
4. Click Apply.

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English