HP 1920 Gigabit Ethernet Switch Series User Manual

73
Item Descri
p
tion
Unicast
Suppression
Set unicast suppression on the port:
• ratio—Sets the maximum percentage of unicast traffic to the total bandwidth of an
Ethernet port. When you select this option, you must enter a percentage in the box
below.
• pps—Sets the maximum number of unicast packets that can be forwarded on an
Ethernet port per second. When you select this option, you must enter a number in the
box below.
• kbps—Sets the maximum number of kilobits of unicast traffic that can be forwarded on
an Ethernet port per second. When you select this option, you must enter a number in
the box below.
Selected Ports
Interface or interfaces that you have selected from the chassis front panel and the
aggregate interface list below, for which you have set operation parameters.
You can set only the state and MAC learning limit for an aggregate interface.
If you set operation parameters that a port does not support, you are notified of invalid settings and might
fail to set the supported operation parameters for the port or other ports.
Displaying port operation parameters
Displaying a specified operation parameter for all ports
1. Select Device > Port Management from the navigation tree.
The Summary page appears by default.
2. Select the option for a parameter you want to view.
The parameter information for all the ports is displayed in the lower part of the page.

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English