HP A5800 Series User Manual

133
One-step patch installation
To install patches in one step, use patch install. After you execute the command, the system displays the
message "Do you want to continue running patches after reboot? [Y/N]:"
• Entering Y: All specified patches are installed, and turn to the RUNNING state from IDLE. This equals
execution of the commands patch location, patch load, patch active, and patch run. The patches
remain RUNNING after system reboot.
• Entering N: All specified patches are installed and turn to the ACTIVE state from IDLE. This equals
execution of the commands patch location, patch load and patch active. The patches turn to the
DEACTIVE state after system reboot.
The patch matches the device type and software version.
To install the patches in one step:
Ste
p
Command Remarks
1. Enter system view.
system-view —
2. Install the patches in
one step.
patch install
patch-location
Required.
To uninstall all patches in one operation, use undo patch
install, which has the same effect as Step-by-step patch
uninstallation.
Step-by-step patch installation
Ste
p
Command Remarks
1. Enter system view.
system-view —
2. Configure the patch
file location.
patch location
patch-location
Optional.
flash: by default.
3. Load the patch file on
from the storage
medium to the
specified memory
patch area.
patch load slot
slot-number
Required.
4. Activate the specified
patches.
patch active
patch-number slot
slot-number
Required.
• After activation, the patch takes effect and is in the
test-run stage. After the device is reset or rebooted, the
patch becomes invalid.
• If an ACTIVE patch has a problem, reboot the device to
deactivate the patch and avoid a series of running faults
resulting from patch error.
5. Confirm the running of
the specified patches.
patch run patch-
number [ slot
slot-number ]
Required.
After you confirm the running of a patch, the patch state
becomes RUNNING, and the patch is in the normal
running stage. After the device is reset or rebooted, the
patch is still valid.
Set the file transfer mode to binary mode before using FTP or TFTP to upload/download patch files to/from
the Flash of the device. Otherwise, patch file cannot be parsed properly.

HP A5800 Series Specifications

General

Brand	HP
Model	A5800 Series
Category	Switch
Language	English