HP A5800 Series User Manual

50
Ste
p
Command Remarks
16. Create an SSH user, and
specify the authentication
mode for the SSH user.
ssh user username
service-type stelnet
authentication-type
{ password | { any |
password-publickey |
publickey } assign
publickey keyname }
Required.
By default, no SSH user exists, and no
authentication mode is specified.
17. Configure common settings
for VTY user interfaces.
—
Optional.
See “Configuring common settings for VTY user
interfaces (optional).”
After you enable command authorization or command accounting, you must perform the following
configuration to make the function take effect:
• Create a HWTACACS scheme, and specify the IP address of the authorization server and other
authorization parameters.
• Reference the created HWTACACS scheme in the ISP domain.
For more information, see Security Configuration Guide.
When users adopt the scheme mode to log in to the device, the level of the commands that the users can
access depends on the user privilege level defined in the AAA scheme.
• When the AAA scheme is local, the user privilege level is defined by the authorization-attribute level
level.
• When the AAA scheme is RADIUS or HWTACACS, the user privilege level is configured on the RADIUS
or HWTACACS server.
• For more information about AAA, RADIUS, and HWTACACS, see Security Configuration Guide.
Configuring the SSH client to log in to the SSH server
Prerequisites
You have logged in to the device.
By default, log in to the device through the console port without authentication and have user privilege level
3 after login. For information about logging in to the device with the default configuration, see
“Configuration requirements.”
Figure 16 Log in to anot
her device from the current device
NOTE:
If the SSH client and the SSH server are not in the same subnet, make sure that the two devices can reach
each other.

HP A5800 Series Specifications

General

Brand	HP
Model	A5800 Series
Category	Switch
Language	English