92
• Download the boot file newest.bin from PC to the root directory of the storage medium of a subordinate
switch (with member ID of 2).
[ftp] get newest.bin slot2#flash:/newest.bin
# Upload the configuration file config.cfg of the device to the server for backup.
[ftp] ascii
[ftp] put config.cfg back-config.cfg
227 Entering Passive Mode (10,1,1,1,4,2).
125 ASCII mode data connection already open, transfer starting for /config.cfg.
226 Transfer complete.
FTP: 3494 byte(s) sent in 5.646 second(s), 618.00 byte(s)/sec.
[ftp] bye
# Specify newest.bin as the main boot file to be used at the next startup for all member devices.
<Sysname> boot-loader file newest.bin slot all main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 1!
The specified file will be used as the main boot file at the next reboot on slot 2!
# Reboot the device, and the boot file is updated at the system reboot.
<Sysname> reboot
Configuring the FTP server
Configuring FTP server operating parameters
The FTP server uses one of the following modes to update a file when you upload the file (use put) to the FTP
server:
• Fast mode—The FTP server starts writing data to the storage medium after a file is transferred to the
memory. This prevents the existing file on the FTP server from being corrupted in the event that anomaly,
power failure for example, occurs during a file transfer.
• Normal mode—The FTP server writes data to the storage medium while receiving data. This means that
any anomaly, power failure for example, during file transfer might result in file corruption on the FTP
server. This mode, however, consumes less memory space than the fast mode.
To Next Page
Loading...
Need help?
General
