148
Configuration procedure
Configure link aggregation
1. Configuration on the IRF virtual switch
# Create three dynamic aggregation groups 1, 2, and 3.
<IRF> system-view
[IRF] interface bridge-aggregation 1
[IRF-Bridge-Aggregation1] link-aggregation mode dynamic
[IRF-Bridge-Aggregation1] quit
[IRF] interface bridge-aggregation 2
[IRF-Bridge-Aggregation2] link-aggregation mode dynamic
[IRF-Bridge-Aggregation2] quit
[IRF] interface bridge-aggregation 3
[IRF-Bridge-Aggregation3] link-aggregation mode dynamic
[IRF-Bridge-Aggregation3] quit
# Add ports GigabitEthernet 1/0/1, GigabitEthernet 2/0/1, and GigabitEthernet 3/0/1 that connect
to Switch A to aggregation group 1.
[IRF] interface GigabitEthernet 1/0/1
[IRF-GigabitEthernet1/0/1] port link-aggregation group 1
[IRF-GigabitEthernet1/0/1] quit
[IRF] interface GigabitEthernet 2/0/1
[IRF-GigabitEthernet2/0/1] port link-aggregation group 1
[IRF-GigabitEthernet2/0/1] quit
[IRF] interface GigabitEthernet 3/0/1
[IRF-GigabitEthernet3/0/1] port link-aggregation group 1
[IRF-GigabitEthernet3/0/1] quit
# Add ports GigabitEthernet 1/0/2, GigabitEthernet 2/0/2, and GigabitEthernet 3/0/2 that connect
to Switch B to aggregation group 2.
[IRF] interface GigabitEthernet 1/0/2
[IRF-GigabitEthernet1/0/2] port link-aggregation group 2
[IRF-GigabitEthernet1/0/2] quit
[IRF] interface GigabitEthernet 2/0/2
[IRF-GigabitEthernet2/0/2] port link-aggregation group 2
[IRF-GigabitEthernet2/0/2] quit
[IRF] interface GigabitEthernet 3/0/2
[IRF-GigabitEthernet3/0/2] port link-aggregation group 2
[IRF-GigabitEthernet3/0/2] quit
# Add ports GigabitEthernet 1/0/3, GigabitEthernet 2/0/3, and GigabitEthernet 3/0/3 that connect
to Switch C to aggregation group 3.
[IRF] interface GigabitEthernet 1/0/3
[IRF-GigabitEthernet1/0/3] port link-aggregation group 3
[IRF-GigabitEthernet1/0/3] quit
[IRF] interface GigabitEthernet 2/0/3
[IRF-GigabitEthernet2/0/3] port link-aggregation group 3
[IRF-GigabitEthernet2/0/3] quit
To Next Page
Loading...
Need help?
General
