HP FlexNetwork MSR 954 User Manual

153
Specifying an MSDP peer
An MSDP peering relationship is identified by an address pair (the addresses of the local MSDP peer
and the remote MSDP peer). To create an MSDP peering connection, you must perform the following
operation on both devices that are a pair of MSDP peers.
If an interface of the router is shared by an MSDP peer and a BGP or MBGP peer at the same time,
As a best practice, specify an MSDP peer by using the IP address of the BGP or MBGP peer.
To specify an MSDP peer:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter MSDP view.
msdp
[
vpn-instance
vpn-instance-name ]
N/A
3. Specify an MSDP peer.
peer
peer-address
connect-interface
interface-type
interface-number
By default, no MSDP peers
exist.
Configuring a static RPF peer
This feature prevents SA messages forwarded by the static RPF peer from undertaking the RPF
check. This simplifies the RPF check mechanism for SA messages.
You can configure an RP policy for the static RPF peer to filter SA messages based on the used IPv4
prefix list that specifies the RP addresses.
If only one MSDP peer is configured on a router, this MSDP peer is considered to be a static RPF
peer.
To configure a static RPF peer:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter MSDP view.
msdp
[
vpn-instance
vpn-instance-name ]
N/A
3. Configure a static RPF peer.
static-rpf-peer
peer-address
[
rp-policy
ip-prefix-name ]
By default, no static RPF peers
exist.
Configuring an MSDP peering connection
This section describes how to configure an MSDP peering connection.
Configuration prerequisites
Before you configure an MSDP peering connection, complete the following tasks:
•
Configure a unicast routing protocol so that all devices in the domain can interoperate at the
network layer.
•
Configure basic MSDP features.

HP FlexNetwork MSR 954 Specifications

General

Brand	HP
Model	FlexNetwork MSR 954
Category	Network Router
Language	English