310
5. Enable MLD.
mld enable
By default, MLD is disabled.
Specifying an MLD version
For MLD to operate correctly, specify the same MLD version for all routers on the same subnet.
To specify an MLD version:
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Specify an MLD version on
the interface.
mld version
version-number
The default setting is 1.
Configuring a static group member
You can configure an interface as a static member of an IPv6 multicast group. Then, the interface
can always receive IPv6 multicast data for the group.
A static group member does not respond to MLD queries. When you complete or cancel this
configuration on an interface, the interface does not send an unsolicited MLD report or done
message.
Configuration guidelines
The interface to be configured as a static member of an IPv6 multicast group has the following
restrictions:
If the interface is MLD and IPv6 PIM-SM enabled, it must be an IPv6 PIM-SM DR.
If the interface is MLD enabled but not IPv6 PIM-SM enabled, it must be an MLD querier.
For more information about IPv6 PIM-SM and DR, see "Configuring IPv6 PIM."
Configuration procedure
To configure a static group member:
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3.
member.
mld static-group
ipv6-group-address [
source
ipv6-source-address ]
By default, the interface is not a
static group member of any IPv6
multicast groups.
Configuring an IPv6 multicast group policy
This feature enables an interface to filter MLD reports by using an ACL that specifies IPv6 multicast
groups and the optional sources. It is used to control the IPv6 multicast groups that the hosts
attached to an interface can join.
This configuration does not take effect on static group members.
To Next Page
Loading...
Need help?
General
