282
Router slots (0 in total):
Router ports (1 in total):
GE1/0/3
The output shows that GigabitEthernet 1/0/3 on Switch A has become a static router port.
# Display static MLD snooping group entries in VLAN 100 on Switch C.
[SwitchC] display mld-snooping static-group vlan 100
Total 1 entries).
VLAN 100: Total 1 entries).
(::, FF1E::101)
Host slots (0 in total):
Host ports (2 in total):
GE1/0/3
GE1/0/5
The output shows that GigabitEthernet 1/0/3 and GigabitEthernet 1/0/5 on Switch C have become
static member ports of the IPv6 multicast group FF1E::101.
MLD snooping querier configuration example
Network requirements
As shown in Figure 79:
The network is a Layer 2-only network.
Source 1 and Source 2 send multicast data to IPv6 multicast groups FF1E::101 and FF1E::102,
respectively.
Host A and Host C are receivers of IPv6 multicast group FF1E::101, and Host B and Host D are
receivers of IPv6 multicast group FF1E::102.
All host receivers run MLDv1 and all switches run MLDv1 snooping. Switch A (which is close to
the multicast sources) acts as the MLD snooping querier.
To prevent the switches from flooding unknown IPv6 packets in the VLAN, enable all the switches to
drop unknown IPv6 multicast packets.
To Next Page
Loading...
Need help?
General
