HP FlexNetwork MSR 954 User Manual

26
Step
Command
Remarks
3. Set the
802.1p priority for
IGMP messages.
dot1p-priority
priority
By default, the 802.1p priority for
IGMP packets is not set.
Setting the 802.1p priority for IGMP messages in a VLAN
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter VLAN view.
vlan
vlan-id
N/A
3.
Set the 802.1p priority for
IGMP messages in the
VLAN.
igmp-snooping dot1p-priority
priority
By default, the 802.1p priority for
IGMP packets is not set.
Configuring IGMP snooping policies
Before you configure IGMP snooping policies, complete the following tasks:
•
Enable IGMP snooping for the VLAN.
•
Determine the ACL used by the multicast group policy.
•
Determine the maximum number of multicast groups that a port can join.
Configuring a multicast group policy
This feature enables the device to filter IGMP reports by using an ACL that specifies the multicast
groups and the optional sources. It is used to control the multicast groups that hosts can join.
Configuration restrictions and guidelines
When you configure a multicast group policy, follow these restrictions and guidelines:
•
This configuration takes effect only on the multicast groups that ports join dynamically.
•
You can configure a multicast group policy globally for all ports in IGMP-snooping view or for a
port in interface view. For a port, the port-specific configuration takes priority over the global
configuration.
Configuration procedure
To configure a multicast group policy globally:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter IGMP-snooping view.
igmp-snooping
N/A
3. Configure a multicast group
policy globally.
group-policy
ipv4-acl-number
[
vlan
vlan-list ]
By default, no
multicast group
policies exist, and hosts can join
any multicast groups.
To configure a multicast group policy on a port:
Step
Command
Remarks
1. Enter system view.
system-view
N/A

HP FlexNetwork MSR 954 Specifications

General

Brand	HP
Model	FlexNetwork MSR 954
Category	Network Router
Language	English