HP FlexNetwork MSR 954 User Manual

44
Figure 17 Creating an RPF route
As shown in Figure 17, the RIP domain and the OSPF domain are unicast isolated from each other.
For the receiver hosts in the OSPF domain to receive multicast packets from the multicast source in
the RIP domain, you must configure Router C and Router D as follows:
•
On Router C, configure a static multicast route for the multicast source and specify Router B as
the RPF neighbor.
•
On Router D, configure a static multicast route for the multicast source and specify Router C as
the RPF neighbor.
NOTE:
A static multicast route is effective only on the multicast router on which it is configured, and will not
be advertised throughout the network or redistributed to other routers.
Multicast forwarding across unicast subnets
Routers forward the multicast data from a multicast source hop by hop along the forwarding tree, but
some routers might not support multicast protocols in a network. When the multicast data is
forwarded to a router that does not support IP multicast, the forwarding path is blocked. In this case,
you can enable multicast forwarding across two unicast subnets by establishing a tunnel between
the routers at the edges of the two unicast subnets.
GE1/0/1
1.1.1.2/24
GE1/0/2
1.1.1.1/24
GE1/0/2
2.2.2.2/24
GE1/0/1
2.2.2.1/24
Source
192.168.0.1/24
Source/Mask
Multicast Routing Table Static on Router C
192.168.0.0/24
Interface
GE1/0/1
RPF neighbor/Mask
1.1.1.1/24
Source/Mask
Multicast Routing Table Static on Router D
192.168.0.0/24
Interface
GE1/0/1
RPF neighbor/Mask
2.2.2.2/24
OSPF domain
RIP domain
Router A Router B Router C
Router D
Receiver
Receiver
Multicast packets
Multicast static route

HP FlexNetwork MSR 954 Specifications

General

Brand	HP
Model	FlexNetwork MSR 954
Category	Network Router
Language	English