HP FlexNetwork MSR 954 User Manual

265
•
If a dynamic router port receives an IPv6 PIMv2 hello message, the aging timer for the port is
specified by the hello message. In this case, the mld-snooping router-aging-time command
does not take effect on the port.
•
MLD multicast-address-specific queries originated by the Layer 2 device trigger the adjustment
of aging timers of dynamic member ports. If a dynamic member port receives such a query, its
aging timer is set to twice the MLD last listener query interval. For more information about
setting the MLD last listener query interval on the Layer 2 device, see "Setting the MLD last
listener query interval."
•
You can set the timers globally for all VLANs in MLD-snooping view or for a VLAN in VLAN view.
For a VLAN, the VLAN-specific configuration takes priority over the global configuration.
Setting the aging timers for dynamic ports globally
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter MLD-snooping view.
mld-snooping
N/A
3.
Set the aging timer for
dynamic router ports
globally.
router-aging-time
seconds
The default setting is 260
seconds.
4.
Set the aging timer for
dynamic member ports
globally.
host-aging-time
seconds
The default setting is 260
seconds.
Setting the aging timers for dynamic ports in a VLAN
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter VLAN view.
vlan
vlan-id
N/A
3.
Set the aging timer for
dynamic
router ports in the
VLAN.
mld-snooping
router-aging-time
seconds
The default setting is 260
seconds.
4.
Set the aging timer for
dynamic member ports in the
VLAN.
mld-snooping host-aging-time
seconds
The default setting is 260
seconds.
Configuring static ports
You can configure the following types of static ports:
•
Static member port—When you configure a port as a static member port for an IPv6 multicast
group, all hosts attached to the port will receive IPv6 multicast data for the group.
The static member port does not respond to MLD queries. When you complete or cancel this
configuration, the port does not send an unsolicited report or done message.
•
Static router port—When you configure a port as a static router port for an IPv6 multicast
group, all IPv6 multicast data for the group received on the port will be forwarded.
To configure static ports:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2 Ethernet
interface view or
Layer 2
aggregate interface view.
interface
interface-type
interface-number
N/A

HP FlexNetwork MSR 954 Specifications

General

Brand	HP
Model	FlexNetwork MSR 954
Category	Network Router
Language	English