EasyManuals Logo
Home>HP>Network Router>FlexNetwork MSR 954

HP FlexNetwork MSR 954 User Manual

HP FlexNetwork MSR 954
400 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
27
Step
Command
Remarks
2.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface
interface-type
interface-number
N/A
3. Configure a multicast group
policy on the port.
igmp-snooping group-policy
ipv4-acl-number [
vlan
vlan-list
]
By default, no multicast group
policies exist on a port, and hosts
attached to the port can join any
multicast groups.
Enabling multicast source port filtering
This feature is supported only on the following ports:
•
Layer 2 Ethernet ports on the HMIM-8GSW, HMIM-24GSW, and HMIM-24GSW-PoE.
•
Fixed Layer 2 Ethernet ports on the following routers:
ï‚¡ MSR1002-4/1003-8S.
ï‚¡ MSR2004-24/2004-48.
ï‚¡ MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A).
ï‚¡ MSR958 (JH300A/JH301A).
This feature enables the device to discard all multicast data packets and to accept multicast protocol
packets. You can enable this feature on ports that connect only to multicast receivers.
You can enable this feature for the specified ports in IGMP-snooping view or for a port in interface
view. For a port, the configuration in interface view has the same priority as the configuration in
IGMP-snooping view, and the most recent configuration takes effect.
Enabling multicast source port filtering for the specified ports
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter IGMP-snooping view.
igmp-snooping
N/A
3. Enable multicast source port
filtering.
source-deny
port
interface-list
By default, multicast source port
filtering is disabled.
Enabling multicast source port filtering for a port
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2 Ethernet
interface view.
interface
interface-type
interface-number
N/A
3. Enable multicast source port
filtering.
igmp-snooping source-deny
By default, multicast source port
filtering is disabled.
Enabling dropping unknown multicast data
This feature is supported only on the following ports:
•
Layer 2 Ethernet ports on the HMIM-8GSW, HMIM-24GSW, HMIM-24GSW-PoE, and
SIC-4GSW.
•
Fixed Layer 2 Ethernet ports on the following routers:

Table of Contents

Other manuals for HP FlexNetwork MSR 954

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP FlexNetwork MSR 954 and is the answer not in the manual?

HP FlexNetwork MSR 954 Specifications

General IconGeneral
BrandHP
ModelFlexNetwork MSR 954
CategoryNetwork Router
LanguageEnglish

Related product manuals