HP FlexNetwork MSR 954 User Manual

350
Tasks at a glance
Remarks
Configuring a BSR
• (Required.) Configuring a C-BSR
• (Optional.) Configuring an IPv6 PIM domain border
• (Optional.) Disabling BSM semantic fragmentation
• (Optional.) Disabling BSM forwarding out of incoming
interfaces
Skip the task of configuring a BSR on an IPv6
network without C-RPs.
(Optional.) Configuring common IPv6 PIM features N/A
(Optional.) Enabling SNMP notifications for IPv6 PIM N/A
(Optional.) Configuring common IPv6 PIM features N/A
Configuration prerequisites
Before you configure IPv6 BIDIR-PIM, configure an IPv6 unicast routing protocol so that all devices
in the domain can interoperate at the network layer.
Enabling IPv6 BIDIR-PIM
Because IPv6 BIDIR-PIM is implemented on the basis of IPv6 PIM-SM, you must enable IPv6
PIM-SM before enabling IPv6 BIDIR-PIM. As a best practice, enable IPv6 PIM-SM on all non-border
interfaces on routers when you deploy an IPv6 BIDIR-PIM domain.
IMPORTANT:
All interfaces on a device must be enabled with the same IPv6 PIM mode.
To enable IPv6 BIDIR-PIM:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enable IPv6 multicast
routing and enter MRIB view.
ipv6 multicast routing
[
vpn-instance
vpn-instance-name ]
By default, IPv6 multicast routing
is disabled.
3. Return to system view.
quit
N/A
4. Enter interface view.
interface
interface-type
interface-number
N/A
5. Enable IPv6 PIM-SM.
ipv6 pim sm
By default, IPv6 PIM-
SM is
disabled.
6. Return to system view.
quit
N/A
7. Enter IPv6 PIM view
ipv6 pim
[
vpn-instance
vpn-instance-name ]
N/A
8. Enable IPv6 BIDIR-PIM
bidir-pim enable
By default, IPv6 BIDIR-
SM is
disabled.

HP FlexNetwork MSR 954 Specifications

General

Brand	HP
Model	FlexNetwork MSR 954
Category	Network Router
Language	English