HP FlexNetwork MSR 954 User Manual

269
Step
Command
Remarks
2. Enter MLD-snooping view.
mld-snooping
N/A
3. Set the maximum response
time
for MLD general
queries.
max-response-time
seconds
The default setting is 10 seconds.
Configuring parameters for MLD general queries and responses in a VLAN
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter VLAN view.
vlan
vlan-id
N/A
3. Set the MLD general query
interval in the VLAN.
mld-snooping query-interval
interval
The default setting is 125
seconds.
4. Set the maximum response
time for MLD general queries
in the VLAN.
mld-snooping
max-response-time
seconds
The default setting is 10 seconds.
Configuring parameters for MLD messages
This section describes how to configure parameters for MLD messages.
Configuration prerequisites
Before you configure parameters for MLD messages, complete the following tasks:
•
Enable MLD snooping for the VLAN.
•
Determine the source IPv6 address of MLD general queries.
•
Determine the source IPv6 address of MLD multicast-address-specific queries.
•
Determine the source IPv6 address of MLD reports.
•
Determine the source IPv6 address of MLD done messages.
•
Determine the 802.1p priority of MLD messages.
Configuring source IPv6 addresses for MLD messages
You can change the source IPv6 address of the MLD queries sent by an MLD snooping querier. This
configuration might affect MLD querier election within the subnet.
You can also change the source IPv6 address of MLD reports or done messages sent by a simulated
member host or an MLD snooping proxy.
To configure the source IP address for MLD messages in a VLAN:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter VLAN view.
vlan
vlan-id
N/A

HP FlexNetwork MSR 954 Specifications

General

Brand	HP
Model	FlexNetwork MSR 954
Category	Network Router
Language	English