228
[CEa3-ospfv3-2-area-0.0.0.0] quit
9. Configure CE b2:
# Enable IPv6 multicast routing.
<CEb2> system-view
[CEb2] ipv6 multicast routing
[CEb2-mrib6] quit
# Assign an IPv6 address to GigabitEthernet 1/0/1.
[CEb2] interface gigabitethernet 1/0/1
[CEb2-GigabitEthernet1/0/1] ipv6 address 10:110:11::1 64
# Configure GigabitEthernet 1/0/1 to run OSPFv3 process 3 in Area 0, and enable MLD on the
interface.
[CEb2-GigabitEthernet1/0/1] ospfv3 3 area 0.0.0.0
[CEb2-GigabitEthernet1/0/1] mld enable
[CEb2-GigabitEthernet1/0/1] quit
# Assign an IPv6 address to GigabitEthernet 1/0/2.
[CEb2] interface gigabitethernet 1/0/2
[CEb2-GigabitEthernet1/0/2] ipv6 address 10:110:6::2 64
# Configure GigabitEthernet 1/0/2 to run OSPFv3 process 3 in Area 0, and enable IPv6 PIM-SM
on the interface.
[CEb2-GigabitEthernet1/0/2] ospfv3 3 area 0.0.0.0
[CEb2-GigabitEthernet1/0/2] ipv6 pim sm
[CEb2-GigabitEthernet1/0/2] quit
# Configure OSPFv3.
[CEb2] ospfv3 3
[CEb2-ospfv3-3] router-id 10.10.10.10
[CEb2-ospfv3-3] area 0.0.0.0
[CEb2-ospfv3-3-area-0.0.0.0] quit
Verifying the configuration
# Display information about the local default-group for IPv6 multicast transmission in each VPN
instance on PE 1.
[PE1] display multicast-domain ipv6 default-group local
MD local default-group information:
Group address Source address Interface VPN instance
239.1.1.1 1.1.1.1 MTunnel0 a
# Display information about the local default-group for IPv6 multicast transmission in each VPN
instance on PE 2.
[PE2] display multicast-domain ipv6 default-group local
MD local default-group information:
Group address Source address Interface VPN instance
239.1.1.1 1.1.1.2 MTunnel0 a
239.1.1.1 1.1.1.2 MTunnel1 b
# Display information about the local default-group for IPv6 multicast transmission in each VPN
instance on PE 3.
[PE3] display multicast-domain ipv6 default-group local
MD local default-group information:
Group address Source address Interface VPN instance
239.1.1.1 1.1.1.3 MTunnel0 a
239.2.2.2 1.1.1.3 MTunnel1 b
To Next Page
Loading...
Need help?
General
