HP FlexNetwork MSR2003 User Manual

277
Tasks at a glance
(Optional.) Configuring Option 18 and Option 37
(Optional.) Configuring DHCPv6 snooping entry auto backup
(Optional.) Setting the maximum number of DHCPv6 snooping entries
(Optional.) Enabling DHCPv6-REQUEST check
Configuring basic DHCPv6 snooping
Follow these guidelines when you configure basic DHCPv6 snooping:
• To make sure DHCPv6 clients can obtain valid IPv6 addresses, specify the ports connected to
authorized DHCPv6 servers as trusted ports. The trusted ports and the ports connected to
DHCPv6 clients must be in the same VLAN.
• If you configure DHCPv6 snooping settings on a Layer 2 Ethernet interface that is a member
port of a Layer 2 aggregate interface, the settings do not take effect unless the interface is
removed from the aggregation group.
To configure basic DHCPv6 snooping:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable DHCPv6 snooping.
ipv6 dhcp snooping enable
By default, DHCPv6 snooping is
disabled.
3. Enter interface view.
interface
interface-type
interface-number
This interface must connect to the
DHCPv6 server.
4. Specify the port as a trusted
port.
ipv6 dhcp snooping trust
By default, all ports are untrusted
ports after DHCPv6 snooping is
enabled.
5. Return to system view.
quit
N/A
6. Enter interface view.
interface
interface-type
interface-number
This interface must connect to the
DHCPv6 client.
7. (Optional.) Enable recording
of client information in
DHCPv6 snooping entries.
ipv6 dhcp snooping binding
record
By default, DHCPv6 snooping
does not record client information.
Configuring Option 18 and Option 37
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
• Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
N/A

HP FlexNetwork MSR2003 Specifications

General

Brand	HP
Model	FlexNetwork MSR2003
Category	Network Router
Language	English