HP FlexNetwork MSR2003 User Manual

312
Step Command Remarks
4. Specify the source
address or source
interface for the tunnel.
source
{ ipv6-address |
interface-type
interface-number }
By default, no source address or interface is
specified for the tunnel.
If you specify a source address, it is used as
the source address of the encapsulated IPv6
packets.
If you specify a source interface, the address of
this interface is used as the source address of
the encapsulated IPv6 packets.
5. Return to system view.
quit
N/A
6. Enter the view of the
interface that connects
the IPv4 public network.
interface
interface-type
interface-number
N/A
7. Enable DS-Lite tunneling
on the interface.
ds-lite enable
By default, DS-Lite tunneling is disabled.
Only after you use this command, the AFTR
can tunnel IPv4 packets from the public IPv4
network to the B4 router.
Configuration example
Network requirements
As shown in Figure 129, configure a DS-Lite tunnel between Router A and Router B, and configure
NAT on GigabitEthernet 2/0/1 on the AFTR, so hosts in the private IPv4 network can access the
public IPv4 network.
Figure 129 Network diagram
Configuration procedure
Make sure Router A and Router B can reach each other through IPv6.
• Configure Router A:
# Specify an IPv4 address for GigabitEthernet 2/0/1.
<RouterA> system-view
[RouterA] interface gigabitethernet 2/0/1
[RouterA-GigabitEthernet2/0/1] ip address 10.0.0.2 255.255.255.0
[RouterA-GigabitEthernet2/0/1] quit
# Specify an IPv6 address for GigabitEthernet 2/0/2, which is the physical interface of the
tunnel.
[RouterA] interface gigabitethernet 2/0/2
[RouterA-GigabitEthernet2/0/2] ipv6 address 1::1 64
[RouterA-GigabitEthernet2/0/2] quit

HP FlexNetwork MSR2003 Specifications

General

Brand	HP
Model	FlexNetwork MSR2003
Category	Network Router
Language	English